Design House 533372 Installationsanleitung PDF herunterladen

JO3132 · 12.16.10 Design House is a registered brand of DHI Corp.

Mequon, WI · 800-558-8700

RECESSED TOILET PAPER HOLDER

lf this accessory is to be mounted in an exsting hole ﬁrst check the dimensions of the hole. This accessory requires a minimum

cut-out of 5

1/8

" x 5

1/8

and a maximum of 5

1/2

" x 5

1/2

". lf it is necessary to cut a new hole, please use the template provided on the

back of the product package or on the back of this instruction sheet to ensure the hole is the right size.

After removing the accessory from the package, cut the template along the outer black edge. Then place the template against the

wall where you wish to cut a new hole. Scribe a line around the template. Then cut out the wall board. (lMPORTANT: When

selecting a location, be sure to stay between the wall studs. DO NOT cut a stud.)

INSTALLATION INSTRUCTIONS

INSTALLATION

1. 2.

3. 4.

Attach the clamp to the accessory by inserting

the screws through the accesory into the

bracket. Turn screws three full turns.

Angle the clamp through the hole by ﬁrst tilting

it to one side, and then the other. Be careful not

to damage the wall board.

Position the accessory squarely with the ﬂange

(outer edge) pressed ﬁrmly against the wall.

Tighten the screws until the clamp is ﬁrmly

secured against the inside of the wall.

clamp accessory

wall cutout

wall

1 2

JO3132 · 12.16.10 Design House is a registered brand of DHI Corp. Mequon, WI · 800-558-8700 RECESSED TOILET PAPER HOLDERlf this accessory is to be m

JO3132 · 12.16.10 Design House is a registered brand of DHI Corp. Mequon, WI · 800-558-8700 Mounting Bracket TemplatePlantilla del Soporte de Montaj

Keine Kommentare

Design House 533372 Installationsanleitung